UNDERSTANDING THE BELT SIZES:

Understanding how belt sizes work is not easy and creates a lot of confusion. 
In the trade, the belts are generally noted 85 cm, 90 cm, 95 cm or 100 cm. However, this size does not correspond to the length of the leather. Indeed, this size corresponds to the distance between the end of the loop and the third hole. This distance is shown in the diagram below.

  

So do not try to measure the total length of a belt, the location of the holes or anything else ... A single measurement is useful for us to make your custom belt. And we will explain how to find it.

Below are 2 ways for good measurement. 

 

HOW TO TAKE THE MEASURE ON YOU:   

We advise you to wear pants without a belt.

1 method: Take a tape measure and go around by passing the tape measure through the loops of the pants. This gives you the right measure. Do not wear pants that are too low or too high.

2 method: If you do not have a tape measure, provide yourself with a string that will serve as a standard. Proceed identically and locate where the string ends. Remove the string and then measure the distance obtained.
Once the correct size has been determined, report the value found in the "SIZE" drop-down menu and add to cart.  

 

HOW TO TAKE MEASUREMENT ON A USED BELT :

Easily determine your belt measurement using a used belt.

Step 1: For this, identify the most used hole. Often the leather around this hole will be marked by the buckle (see diagram below).

Step 2: Once the hole has been identified, measure the distance from this hole to the end of the loop.

Step 3: Once the measurement is established, select it from the "SIZE" drop-down menu.

NB: If you use 2 different holes depending on the pants, take in the middle of these 2 holes and measure its distance to the end of the loop.

 

 

 

Our belts are made in France with love.